Without a software or application hacking is not easy, but with application and software hacking is simple. I Know this sound crazy to you How? don't worry just read this article you will find out how easy it is.
Android is an operating system based on Linux Kernel, that is why many hack tricks are possible with it.
There are many fake android WiFi hack application which claims to hack WiFi in one clicks. Don't believe it
there is not such app exist now.
Note: Not every android device can hack WIFI and also it may take hours for the successful one to hack the WiFi.
How to Hack WiFi Using Android?
You can proceed only if your device meet this criteria. Else it is waste of time and energy.
1. Your Android device must be rooted otherwise will not work for you.
2. Make sure your Android device support Bcmon App (such that should have a Broadcom bcm 4329/4330 WiFi chip set.
Tools Used in this Tutorial:
Bcmon app:
- Allows you to enter into the monitor mode
- It also lets you crack the WPS PIN
- In order this app to use you need to install reaver app in your android
Note: Your android must be rooted as Bcmon works only on rooted Android devices. You can root
Android using Kingroot App or other rooting application which will be compatible with your
Android device.
How to install Bcmon APK
1. Download it by clicking Here
2. After downloaded it install it on your android device
3. Make sure the third part installations is ticked. To do this go to settings and then applications and check a tick on the "Unknown Sources".
Now lets start Hacking WIFI
1. Open Bcmon. it may crash for the first time just keep trying. If fail after 5-6 attempts then
sorry the device is not supported.
2. If is open to you. Install the firmware and tools, as prompted. Click on Enable Monitor Mode.
3. Then open Reaver and run it. If you did not install Reaver click Here
Reaver will scan for available access point. Remember it can hack only WPS enabled WiFi.
Make sure Monitor Mode is turned on. and make sure you checked the box Automatic Advance Settings
Choose the network to hack and tap Start Attack. Go and grab coffee or tea, It will take between 2-10 hours
to complete. Is depend on the router type.
Step: 1
1. Open Bcmon and click on Run Bcmon terminal. This will lunch a terminal similar to Linux terminals.
2. On the terminal type airodump-ng and press the Enter button.
3. In the newly opened window type airodump-ng wlan0 and press the Enter button
Step: 2
1. Open Reaver and write down the WiFi Access point name, Mac Address, Broadcasting channel of the
WiFi you want hack.
2. After that start scanning the target WiFi type the following
"airodump-ng -c channel# --bssid MAC address -w outputfile ath0"
3. The complete command look like this:
airodump-ng -c 9 --bssid 00:19:3D:7R:20:11 -w outputfile ath0
Note: The Channel, broadcasting channel, MAC address is the one you write down. -w is for specifying the output file name. You can write any name
Step: 3
1. Leave it to continue scanning until it collects 25,000-35,000 packets.
2. After you collect enough packets go to terminal and type aircrack-ng outputfile*.cap and press enter.
Aircrack program will crack the WiFi password from the extracted packets.
Step: 4
Note that it might take some hours to crack. if it is success you will receive a message Key Found will appear, followed by the password in hexadecimal form.
the password will work only if the Probability is 100%.
Step: 5
Then extract the key it is in this format 34:23:23:23:, remove all : and use it like this 34232323.
